ZyXEL Communications P-660HN-51 User Manual page 64

Figure 18 Wireless > General: Basic (WEP)
The following table describes the labels in this screen.
Table 10 Wireless > General: Basic (WEP)
LABEL DESCRIPTION
Security Level Select Basic to enable WEP data encryption.
more.../less Click more... to show more fields in this section. Click less to hide them.
Password 1~4 The password (WEP keys) are used to encrypt data. Both the Zyxel Device and the
wireless stations must use the same password (WEP key) for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure at least one password, only one password can be activated at any
one time. The default password is Passowrd 1.
WEP Encryption Select 64-bits or 128-bits.
This dictates the length of the security key that the network is going to use.
Chapter 6 Wireless
P-660HN-51 User's Guide
64