Preamble Type - ZyXEL Communications P-660HN-51 User Manual

point is the WPS registrar, the enrollee, or was not involved in the WPS handshake; a rogue device
must still associate with the access point to gain access to the network. Check the MAC addresses of
your wireless clients (usually printed on a label on the bottom of the device). If there is an unknown
MAC address you can remove it or reset the AP.

6.9.9 Preamble Type

Preamble is used to signal that data is coming to the receiver. Short and long refer to the length of the
synchronization field in a packet.
Short preamble increases performance as less time sending preamble means more time for sending
data. All IEEE 802.11 compliant wireless adapters support long preamble, but not all support short
preamble.
Use long preamble if you are unsure what preamble mode other wireless devices on the network
support, and to provide more reliable communications in busy wireless networks.
Use short preamble if you are sure all wireless devices on the network support it, and to provide more
efficient communications.
Use the dynamic setting to automatically use short preamble when all wireless devices on the network
support it, otherwise the Zyxel Device uses long preamble.
Note: The wireless devices MUST use the same preamble mode in order to communicate.
Chapter 6 Wireless
P-660HN-51 User's Guide
90