OAM F4 or F5 tests are used to check virtual path or virtual channel availbility between two DSL devices.
Segment flows are terminated at the connecting point which terminates a VP or VC segment. End-to-
end flows are terminated at the end point of a VP or VC connection, where an ATM link is terminated.
Segment loopback tests allow you to verify integrity of a PVC to the nearest neighboring ATM device.
End-to-end loopback tests allow you to verify integrity of an end-to-end PVC.
Note: The DSLAM to which the Zyxel Device is connected must also support ATM F4 and/or F5
to use this test.
Note: This screen is available only when you configure an ATM layer-2 interface.
Figure 128 Maintenance > Diagnostic > OAM Ping Test
The following table describes the fields in this screen.
Table 99 Maintenance > Diagnostic > OAM Ping Test
LABEL
DESCRIPTION
Select a PVC on which you want to perform the loopback test.
F4 segment
Press this to perform an OAM F4 segment loopback test.
F4 end-end
Press this to perform an OAM F4 end-to-end loopback test.
F5 segment
Press this to perform an OAM F5 segment loopback test.
F5 end-end
Press this to perform an OAM F5 end-to-end loopback test.
Chapter 29 Diagnostic
P-660HN-51 User's Guide
223