Table of Contents
Advertisement
GS1 Data
Bar Composite symbols
Code data read will be transmitted as is.
GTIN Format Conversion is not applied.
Under the conditions "Code ID mark: Type 1" and " output mode: Separating," a separator (GS: 1Dh) and 2D code ID
mark are inserted between the li
refer to (5) Code ID mark on pages 35 to 41.)
Under the conditions "Code ID mark: Type
inserted between the linear component and 2D Composite component.
(Note)
GS1 DataBar includes:
GS1 DataB
ar Omnidirectional(RSS-14),
GS1 DataBar Truncated(RSS-14 Truncated),
GS1 DataBar Li
mited(RSS Limited),
GS1 DataBar Expa
GS1 DataBar Stacked(RSS-14 Stacked),
GS1 DataBar Expanded Stacked(RSS Expanded Stacked),
GS1 DataBar Stacked Omnidirectional(RSS-14 Stacked Omnidirectional)
UPC/EAN Composite symbols
Code data read will be transmitted as is.
The format setting for each code does not apply to the linear component (UPC-A/UPC-E
GTIN Format Conversion is not applied.
Under the con
ditions "Code ID mark: Type 1" and "Code ID mark output mode: Separating," a separator (GS: 1Dh)
and 2D code ID mark are inserted betwee
Under the conditions "Code ID mark: Type 4," the 2D code ID mark is inserted between the linear componen
Composite component. (For details about the code ID mark, refer to (5) Code ID mark on pages 35 to 41.)
UPC
/EAN Composite symbols with add-on
Cod
e data read will be transmitted as is.
The
format setting for each code does not ap
GTI
N Format Conversion is not applied.
Und
er the conditions "Code ID mark: Type 1" and "Code ID mark output m
and
2D code ID mark are inserted between the linear component and 2D Co
Under the conditions "Code ID mark: Type 4" and "Code ID mark output mode: Coupling", the 2D code ID mark is
inserted between the linear component and 2D Composite component.
Under the conditions "Code ID mark: Type 4" and "Code ID mark output mode: Separating", the 2D code ID mark is
inserted before add-on portion and between the linear component and 2D Composite component. (For details about
the code ID mark, refer to (5) Code ID mark on pages 35 to 41.)
GS1-128 Composite symbols
Code data read will be transmitted as is.
The format setting for each code does not apply to the linear component (GS1-128) format.
GTIN Format Conversion is not applied.
Under the conditions "Code ID mark: Type 1" and "Code ID mark output mode: Separating," a separator (GS: 1Dh)
and 2D code ID mark are inserted between the linear component and 2D Composite component.
Under the conditions "Code ID mark: Type 4" and "Linear component length: Variable," a separator (GS: 1Dh) is
inserted between the linear component and 2D Composite component.(For details about the code ID mark, refer to (5)
Code ID mark on pages 35 to 41.)
near component and 2D Composite component. (For details about the code ID mark,
4" and "Linear component length: Variable," a separator (GS: 1Dh) is
nded(RSS- Expanded),
n the linear component and 2D Composite component.
ply to the linear component (UPC-A/UPC-E/EAN-13/EAN-8) format.
ode: Separating", a separator (GS: 1Dh)
mposite component.
48
/EAN-13/EAN-8) format.
t and 2D
Advertisement
Table of Contents
