Table of Contents
Advertisement
Control Commands
See Parameter Details,
TR
MENULOCK
(Note 4) (Note 5)
MENUUNLOCK
(Note 4) (Note 5)
VER
IR
IZ
ID
See Parameter Details,
DLV
[6] given later.
PW
(Note 4) (N ote 5)
See Parameter Details,
IS
[7] given later.
See Param
VOLSND
[8] given
(
Note
1) When the power is
If the scanner receives an R command, sends the code data read, and receives Z and R commands with a code being
applied to
the scanning window of
command c
ancels the double-read pre
(Note 2) If the scanner receives a control command successfully, it returns an "OK" response to the host. If the format or
parameter
of the received control co
(Note 3) The scanne
r can read codes e
(
Note
4) To make the scanne
OFF until the host r
(
Note
5) These commands c
flash ROM.
(
Note
6) The scanne
r can read codes even di played on a paper nder some conditions.
Parameter
OK/NG
[5] given later.
None
OK/NG
None
OK/NG
None
Ver.n.nn
None
OK/NG
None
OK/NG
Non
e
ID. nnnnnn
OK/NG
None
OK/N
OK/NG
eter De
tails
,
OK/N
later.
ON, the s
canner is rea
the scanner, then it
ven
mmand is invalid
ven displayed on a mobile'
r save se
ttings m
ade with control
eturns a
n "OK" o
r "NO" response. oing so may cause the scanne
an save
settings i
nto the flash ROM maximum of 1,000,000 time
s
Response
Specify the double-read prevention timeout.
(Note 2)
Enable restriction on the use of QR-coded parameter
(Note 2)
menu.
Disable restriction on the use of QR-coded parameter
(Note 2)
menu.
Request for software version.
<Response from the scanner> Ver. n.nn
where n.nn is version number (Ex. Ver. 1.00)
Enable transmission of scanner ID.
(Note 2)
Disable transmission of scanner ID.
(Note 2)
Request for scanner ID (serial number)
<Response from the scanner> "ID. nnnnnn"
where nnnnnn is a serial number (Ex. ID. 000001)
Spec
ify the bar code scanning level (1 to 8).
(Note 2)
Save parameter values.
This command save
G
(Not
e 2)
commands into the flash ROM. Without a PW command,
the scanner lose
when it is turne
Play back an audio data file specified by index, with the
specified playback volume.
(Note 2)
If the scanner receives two or more IS com
succession, it plays back the audio data file specified by
the last command.
Specify the playback volume for an a
G
(Not
e 2)
specified by index.
dy to scan
.
sends even the same code data twice. This is becaus
tion pro
cessing
.
, th
e scanner returns an "NG" response.
s LCD under some conditions.
co
mmands into the flash R
D
a
u
94
Function
s settings made with control
s settings made with control commands
d OFF.
udio data file
OM, do not turn the scanner power
r to malfunction.
s due to the restrictions on the
mands in
e the Z
Advertisement
Table of Contents
