Table of Contents
Advertisement
Windows XP
(1) Switch the computer on to run Windows XP. Log on
(2) Connect the scanner's USB interface cable to th
as an Administrator.
e computer or USB hub.
(3)
Wait for the Found N
Windows task tray.
Windows will automatically configure the scanner. Upon
completion of the configuration, the screen shown at left
automatically disappears.
(4) To check whether the USB device is working normally, open
the Windows Device Manager.
If USB Human Interface Device is added to the sub-tree of
Human Interface Devices as shown at left, the scanner is
connected normally.
If the device is not added or it is marked with
remove this driver with the uninstaller, reboot your
computer, and perform the above connection process again.
6
ew Hardware hint to pop up on the
or
,
Advertisement
Table of Contents
