Interlock Switches - Ricoh MD-P2 Field Service Manual

2. Install the removed NVRAM on the new EGB with the mark [A] pointing to the right side of the
board after you replace the EGB.
3. Replace the NVRAM if the NVRAM on the old EGB is defective.
• Keep the NVRAM away from objects that can cause static electricity. Static electricity can damage
NVRAM data.
• Make sure that the NVRAM is correctly installed on the EGB.

Interlock Switches

1. Operation panel (
2. Rear cover ( p.25)
3. Left cover ( p.27)
4. Remove the spring [A].
p.26)
Electrical Components
4
81