Supero 7047GR-TPRF User Manual page 65

NIC1/NIC2 LED Indicators
The NIC (Network Interface Controller)
LED connection for GLAN port 1 is
located on pins 11 and 12 of JF1, and
the LED connection for GLAN Port 2 is
on Pins 9 and 10. Attach the NIC LED
cables here to display network activity.
Refer to the table on the right for pin
definitions.
Overheat (OH)/Fan Fail/PWR Fail/
UID LED
Connect an LED cable to pins 7 and
8 of Front Control Panel to use the
Overheat/Fan Fail/Power Fail and UID
LED connections. The Red LED on pin
7 provides warnings of overheat, fan
failure or power failure. The Blue LED
on pin 8 works as the front panel UID
LED indicator. The Red LED takes
precedence over the Blue LED by
default. Refer to the table on the right
for pin definitions.
Power Fail LED
The Power Fail LED connection
is located on pins 5 and 6 of JF1.
Refer to the table on the right for pin
definitions.
Reset Button
The Reset Button connection is located
on pins 3 and 4 of JF1. Attach it to a
hardware reset switch on the computer
case. Refer to the table on the right for
pin definitions.
Chapter 5: Advanced Serverboard Setup
Pin Definitions (JF1)
Pin#
9
10
11
12
OH/Fan Fail/ PWR Fail/Blue_UID
LED Pin Definitions (JF1)
Pin# Definition
7 Red_LED-Cathode/OH/Fan Fail/
Power Fail5.5V.SB
8 Blue_UID LED
OH/Fan Fail/PWR Fail
LED Status (Red LED)
State
Off
On
Flashing
Pin Definitions (JF1)
Pin#
5
6
Pin Definitions (JF1)
Pin#
3
4
5-17
GLAN1/2 LED
Definition
Vcc
NIC 2 LED
Vcc
NIC 1 LED
Definition
Normal
Overheat
Fan Fail
PWR Fail LED
Definition
3.3V
PWR Supply Fail
Reset Button
Definition
Reset
Ground