Dismantling Instructions - Indesit ICD661UK Service Information

Indesit Company

DISMANTLING INSTRUCTIONS

1. Refer to Safety Notes at the beginning of this Manual.
2. Hand and Sleeve Protection must be worn when working on the Inner Door and Tank.
3. The majority of the electrical tag connections have a locking tab and insulating shroud fitted. It
may be easier to release the tag locking tab, if the shroud is temporarily removed from the tag.
4. Electrical Connections are not polarised, therefore a note must be made of the orientation of all
connections before disconnecting.
5. Tank Earth. When ever the tank is removed from the machine, the earthing connection must be
refitted.
Tank
Earth
Connection
A. SEPARATING INNER & OUTER DOOR PANELS
1. Remove the 6 Philips screw (3 each side) from around
the edge of the inner door, whilst supporting the outer
door panel.
2. The On/Off, LED, start cards and selector are attached
to the outer door panel. The outer door panel cannot
be completely removed unless these components are
released from the door panel.
See (F).
B. INNER DOOR PANEL
1. Separate the inner and outer door panels.
2. Noting the connections disconnect the soap/rinse aid dispenser and door lock.
3. Release the 2 hinge springs.
4. WARNING: - The inner door panel is very sharp. Holding the inner door panel remove 2 hinge fixing
screws from either side.
5. Remove the dispenser (E) and door lock (D) from the inner door panel.
Service Manual UK
18 of 28
English