Advertisement
Quick Links
Positioning and levelling
Connecting the water and electricity supplies
Technical data
Electrical Connection
Overall view
Control panel
Display
Lower rack
Cutlery basket
Upper rack
Starting the dishwasher
Loading the detergent
Washing options
Wash cycle table
Loading the rinse aid
Loading the refined salt
Shutting off the water and electricity supplies
Cleaning the dishwasher
Preventing unpleasant odours
Cleaning the sprayer arms
Cleaning the filters
Leaving the machine unused for extended periods
General safety
Disposal
Saving energy and respecting the environment
Advertisement
Related Manuals for Indesit IDE 750
Summary of Contents for Indesit IDE 750
- Page 1 Electrical Connection Overall view Control panel Display Lower rack Cutlery basket Upper rack Starting the dishwasher Loading the detergent Washing options Wash cycle table Loading the rinse aid Loading the refined salt Shutting off the water and electricity supplies Cleaning the dishwasher...
- Page 2 If it has been damaged, contact the retailer and do not proceed any further with the installation process. 2. Check the dishwasher by placing it so that its sides or back panel are in contact with the adjacent cabinets or even with the wall. This appliance can also be recessed under a single worktop* ( see the Assembly instruction sheet ).
- Page 3 Power supply See appliance data plate voltage Total absorbed See appliance data plate power Fuse See appliance data plate This dishwasher conforms to the following European Community Directives: -73/23/EEC dated 19/02/73 (Low Voltage) and subsequent modifications -89/336/EEC dated 03/05/89 (Electromagnetic Compatibility)
- Page 4 Electrical Connection If your appliance is supplied with a 13 amp. fused plug it can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instruction below. Replacing the fuse: When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover re-fitted.
- Page 5 button button* indicator light* indicator light* indicator light Upper rack Upper sprayer arm Tip-up compartments Rack height adjuster Lower rack Lower sprayer arm Cutlery basket Washing filter Salt dispenser Detergent and rinse aid dispensers Data plate button* indicator light indicator light * Only available in selected models.
- Page 6 When buying crockery and cutlery we recommend that you check whether it can be washed using the dishwasher. To wash the upper and lower rack handles: remove the two fastening plugs, lift out the handles and rinse them under running water, then fasten them to the rack using the same plugs.
- Page 7 Press the ON/OFF button and open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Press the ON/OFF button again: the cycle starts from the point at which it was interrupted. If the door is opened during the wash cycle, or if there is a power cut, the cycle stops.
- Page 8 INDESIT dishwashers are equipped with an automatic filter cleaning system so that they do not become clogged with food residues. This function may extend the duration of the wash cycles. If there is a high level of dirt contained in the filters, the dishwasher will stop operating (see Troubleshooting - Blocked filter alarm) .
- Page 9 Refined salt removes limescale from the water, thus avoiding the formation of deposits on crockery. The salt dispenser is located in the lower part of the dishwasher ( see Description ) and should be filled: •...
- Page 10 3. Reconstruct the filter assembly and replace it in the correct position, following movements 1 and 2 as shown in the figure, until it clicks into place. • Run a wash cycle when the dishwasher is empty. • Unplug the appliance and disconnect the water supply.
- Page 11 Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. • Only start a wash cycle when the dishwasher is full. While waiting for the dishwasher to be filled, prevent unpleasant odours with the Soak cycle ( see Wash Cycles ).
- Page 12 Whenever the appliance fails to work, check for a solution from the following list before calling for Technical Assistance Centre. Some problems are indicated by specific codes that flash on the display: make a note of any codes displayed before calling Assistance.