Indesit ICD661UK Service Information page 20

Indesit Company
5. Selector: - Whilst pulling on the knob, from
inside the console push the knob tabs
inwards to release. Remove the fixing nut
and washer from the selector shaft.
6. Release the handle cover fixing screws
and release the wiring to the LED card.
When refitting remember to route the
harness behind the handle cover clip.
7. LED Card: - Remove the 2 LED card fixing
screws.
8. Gain access to the module (G).
9. Noting the connector positions,
disconnected the relevant edge connectors
from the module.
10. Pull the wiring through from the module to
release all the components.
11. Reconnect the module, route the wiring
and refix all the components to the outer door panel.
Service Manual UK
20 of 28
Selector Fixing Nut
English