Removing The Headlight Mask With The Headlight - Husqvarna FE 450 2016 Owner's Manual

15 ELECTRICAL SYSTEM
15.6

Removing the headlight mask with the headlight

–
Remove the defective fuse.
Guideline
Fuse 1 - 10 A - EFI control unit
Fuse 2 - 10 A - fuel pump
Fuse 3 - 10 A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 4 - 10 A - horn, brake light, turn signal, radiator fan
Fuses res - 10 A - spare fuses
S00901-10
Info
A defective fuse is indicated by a burned-out fuse wire
Warning
Fire hazard The electrical system can be overloaded if the wrong fuses
are used.
–
–
Use spare fuses with the correct rating only.
Fuse (75011088010) (
Tip
Replace the spare fuse in the fuse box so that it is available if needed.
–
Check that the power consumer is functioning properly.
–
Close the fuse box cover.
Finishing work
–
Mount the seat. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
Main work
(FE EU/AU)
–
Detach brake line
–
Release rubber straps
S00513-10
–
Detach plug-in connectors
light.
H00220-10
(FE US)
–
Detach brake line
–
Release rubber straps
S00514-10
Use only fuses with the prescribed amperage. Never bypass or repair
fuses.
p. 110)
p. 50)

and wiring harness

. Slide the headlight mask up and swing it forward.

and take off the headlight mask with the head-

and wiring harness

. Slide the headlight mask up and swing it forward.

.

.

.
85