12
SERVICE WORK ON THE CHASSIS
12.28
Removing the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
–
Mount and tighten screws
Guideline
Screw, subframe
–
Remove screws
–
Mount and tighten screws
Guideline
Screw, subframe
S00914-10
–
Lower the swingarm.
H00224-11
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever on angle lever
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
H00185-13
(FE EU)
–
Route cable avoiding stress; connect plug-in connector
and secure with a new cable binder.
H00225-11
Finishing work
–
Install the fuel tank.
–
Install the main silencer. (
–
Install the right side cover. (
–
Mount the seat. (
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Remove the right side cover. (
on both sides.
M8
on both sides.
on both sides.
M8
.
M14x1.5
.
M10
(
p. 60)
p. 57)
p. 58)
p. 50)
p. 58)
35 Nm
Loctite
®
2701™
(25.8 lbf ft)
Loctite
®
2701™
35 Nm
(25.8 lbf ft)
80 Nm (59 lbf ft)
60 Nm
Loctite
®
2701™
(44.3 lbf ft)
on lambda sensor
p. 42)
55