Changing The Headlight Bulb - Husqvarna FE 450 2016 Owner's Manual

15 ELECTRICAL SYSTEM
15.8

Changing the headlight bulb

Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
–
Position brake line
S00894-10
Finishing work
–
Check the headlight setting. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
(FE EU/AU)
–
Turn protection cap
clockwise all the way and remove it.
–
Pull bulb socket
S00507-10
(FE US)
–
Turn protection cap
clockwise all the way and remove it.
–
Pull bulb socket
M00433-10
–
Pull out headlight bulb
–
Insert the new headlight bulb.
Headlight (HS1 / Sockel PX43t) (
–
Insert the protection cap with the bulb socket into the reflector and turn it clock-
wise all the way.
–
Ensure that O-ring
–
Insert the bulb socket of the parking light into the reflector.
S00508-10
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (

and wiring harness
p. 88)

together with the underlying bulb socket counter-

of the parking light out of the reflector.

together with the underlying bulb socket counter-

of the parking light out of the reflector.

.
p. 110)

is seated properly.
p. 88)

in the brake line guide.
p. 85)
p. 86)
87