12
SERVICE WORK ON THE CHASSIS
12.10
Installing the lower triple clamp
Main work
–
Open cable holder
H00215-10
–
Remove screw
handlebar and set it aside.
Info
Cover the components to protect them against damage.
Do not bend the cables and lines.
H00216-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
C00567-11
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Position the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
–
Check whether the upper steering head seal
–
Mount protective ring
M00420-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the clutch line next to the voltage regulator.
H00217-10
in front of the right radiator and detach the wiring harness.
. Remove screw
, take off the upper triple clamp with the
. Remove protective ring
p. 114)
and O-ring
but do not tighten yet.
.
is correctly positioned.
.
45