11
TUNING THE CHASSIS
11.15
Adjusting the handlebar position
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace han-
dlebar.
–
Remove screws
lay it to one side.
Info
Cover the components to protect them against damage.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten
screws
101860-10
Guideline
Screw, handlebar holder
Info
Position the left and right handlebar holders evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap width is even.
. Take off the handlebar clamps. Take off the handlebar and
. Take off the handlebar supports.
.
M10
40 Nm
Loctite
(29.5 lbf ft)
evenly.
M8
20 Nm (14.8 lbf ft)
41
®
243™