Memory Installation Guidelines; Installing Dimm Memory Modules; Removing Dimm Memory Modules - Supermicro X10SDV User Manual

X10SDV Flex ATX Series Motherboard User's Manual

Memory Installation Guidelines

When installing memory modules, the DIMM slots should be populated in the following
order: DIMMA1, DIMMB1, then DIMMA2, DIMMB2.
• Always use DDR4 DIMM modules of the same size, type and speed. Mixing
memory modules of different types and speeds is not allowed.
• The motherboard will support one DIMM module installed. However, for best
memory performance, install DIMM modules in pairs.

Installing DIMM Memory Modules

1. Align the key on the bottom of the DIMM module against the key on the mem-
ory slot. Take note of the notches on the side of the DIMM module, and of the
locking clips on the socket to avoid causing damage.
2. Install the DIMM module straight down into the socket until it is securely seat-
ed in the socket. The side clips will automatically lock the module into place.

Removing DIMM Memory Modules

Reverse the steps above to remove the DIMM modules from the motherboard.
Socket Key
Module Key
2-8
Module Notch
Locking Clip