Sysname - HP FlexFabric 7900 Series Command Reference Manual

Usage guidelines
This command is supported only on an HPE 7910/HPE 7910 TAA switch.
Isolating a switching fabric module or some of its channels reduces the forwarding bandwidth of the
system. If the device has only one switching fabric module, isolating the module disables the device
from forwarding traffic. To minimize impact on forwarding performance, isolate only the failed
channels.
Only one switching fabric module can be isolated at a moment.
Examples
# In standalone mode, isolate the switching fabric module in slot 10.
<Sysname> system-view
[Sysname] switch-fabric isolate slot 10
The command will isolate the switch fabric or a channel from the system. Continue? [Y/N]
# In IRF mode, isolate channel 1 on the switching fabric module in slot 10 of member device 1.
<Sysname> system-view
[Sysname] switch-fabric isolate chassis 1 slot 10 channel 1
The command will isolate the switch fabric or a channel from the system. Continue? [Y/N]

sysname

Use sysname to set the device name.
Use undo sysname to restore the default.
Syntax
sysname sysname
undo sysname
Default
The default name is HPE.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
sysname: Specifies a name for the device, a string of 1 to 64 characters.
Usage guidelines
A device name identifies a device in a network and is used as the user view prompt at the CLI. For
example, if the device name is Sysname, the user view prompt is <Sysname>.
Examples
# Set the name of the device to R2000.
<Sysname> system-view
[Sysname] sysname R2000
[R2000]
250