Tftp Commands; Tftp - HP FlexFabric 7900 Series Command Reference Manual

TFTP commands

The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for
features, commands, and parameters might differ in FIPS mode and non-FIPS mode. For more
information about FIPS mode, see Security Configuration Guide.
TFTP is not supported in FIPS mode.

tftp

Use tftp to download a file from the TFTP server to the local device or upload a local file to the TFTP
server in an IPv4 network.
Syntax
tftp tftp-server { get | put | sget } source-filename [ destination-filename ] [ vpn-instance
vpn-instance-name ] [ dscp dscp-value | source { interface interface-type interface-number | ip
source-ip-address } ]
Views
User view
Predefined user roles
network-admin
mdc-admin
Parameters
tftp-server: Specifies the IPv4 address or host name of a TFTP server. The host name can be a
case-insensitive string of 1 to 253 characters and can contain only letters, digits, hyphens (-),
underscores (_), and dots (.).
get: Downloads a file and writes the file directly to the destination folder. If the destination folder
already has a file using the same name, the system deletes the existing file before starting the
download operation. The existing file is permanently deleted even if the download operation fails.
put: Uploads a file.
sget: Downloads a file and saves the file to memory before writing it to the destination folder. The
system starts to write the file to the destination folder only after the file is downloaded and saved to
memory successfully. If the destination folder already has a file using the same name, the system
overwrites the existing file. If the download or save-to-memory operation fails, the existing file in the
destination folder is not overwritten.
source-filename: Specifies the source file name, a case-insensitive string of 1 to 1 to 255 characters.
destination-filename: Specifies the destination file name, a case-insensitive string of 1 to 255
characters. If this argument is not specified, the file uses the source file name.
vpn-instance vpn-instance-name: Specifies the VPN instance to which the remote host belongs,
where vpn-instance-name is a case-sensitive string of 1 to 31 characters. If the remote host belongs
to the public network, do not specify this option.
dscp dscp-value: Specifies the DSCP value for IPv4 to use for outgoing TFTP packets to indicate the
packet transmission priority, in the range of 0 to 63. The default is 0.
source { interface interface-type interface-number | ip source-ip-address }: Specifies the source
address for outgoing TFTP packets. If this keyword is not specified, the device uses the primary IPv4
address of the output interface for the route to the server as the source IPv4 address of outgoing
TFTP packets.
111