Bootrom Backup - HP FlexFabric 7900 Series Command Reference Manual

•
The backup image list is used if the active MPU or global active MPU started up with the main
startup images.
The startup images synchronized to the standby MPU are set as main startup images, regardless of
whether the source startup images are main or backup.
To avoid problems, make sure the image list used for synchronization is the same as the current
software images list.
Startup image synchronization fails if any software image being synchronized is not available or is
corrupted.
Examples
# On an HPE 7910/HPE 7910 TAA switch in standalone mode, synchronize startup images from the
active MPU to the standby MPU in slot 11.
<Sysname> boot-loader update slot 11
This command will update the specified standby MPU. Continue? [Y/N]:y
Updating. Please wait...
Copying main startup software images to slot 11. Please wait...
Done.
Setting copied images as main startup software images for slot 11...
Done.
Successfully updated the startup software images of slot 11.
# On an HPE 7910/HPE 7910 TAA IRF fabric, synchronize startup images from the global active
MPU to the MPU in slot 11 of member device 1.
<Sysname> boot-loader update chassis 1 slot 11
This command will update the specified standby MPU. Continue? [Y/N]:y
Updating. Please wait...
Copying main startup software images to chassis 1 slot 11. Please wait...
Done.
Setting copied images as main startup software images for chassis 1 slot 11...
Done.
Successfully updated the startup software images of chassis 1 slot 11.
Related commands
display boot-loader

bootrom backup

Use bootrom backup to back up the BootWare image in the Normal area to the Backup area on a
BootWare.
Syntax
In standalone mode:
bootrom backup slot slot-number-list
In IRF mode:
bootrom backup chassis chassis-number slot slot-number-list
Views
User view
Predefined user roles
network-admin
161