Terminal Type - HP FlexFabric 12900 series Command Reference Manual

Views
System view
Predefined user roles
network-admin
Usage guidelines
This command is not supported in FIPS mode.
Administrators can Telnet to the device only when the Telnet server function is enabled.
Examples
# Enable the Telnet server function.
<Sysname> system-view
[Sysname] telnet server enable

terminal type

Use terminal type to specify the terminal display type.
Use undo terminal type to restore the default.
Syntax
terminal type { ansi | vt100 }
undo terminal type
Default
The terminal display type is ANSI.
Views
User line view, user line class view
Predefined user roles
network-admin
Parameters
ansi: Specifies the terminal display type ANSI.
vt100: Specifies the terminal display type VT100.
Usage guidelines
The device supports two terminal display types: ANSI and VT100. HP recommends that you set the
display type to VT100 on both the device and the configuration terminal. If either side uses the ANSI type,
a display problem such as cursor positioning error might occur when a command line has more than 80
characters.
Examples
# Set the terminal display type to VT100.
<Sysname> system-view
[Sysname] line vty 0
[Sysname-line-vty0] terminal type vt100
43