Statistic Mode - HP FlexFabric 12900 series Command Reference Manual

Usage guidelines
The device starts a detection timer when a port is shut down by a protocol. If the port is still down when
the detection timer expires, the device automatically brings up the port so the port status reflects the port's
actual physical status.
If you change the detection timer to T1 during port detection, the interval from when you change the timer
to the time when the protocol module shuts down the port is T. If T<T1, the down port will be recovered
after T1-T time. If T>=T1, the down port is recovered immediately. For example, if the detection timer is set
to 30 seconds and you change it to 10 seconds (T1=10) two seconds after the port is shut down (T=2),
this port will be recovered 8 seconds later. If the detection timer is set to 30 seconds and you change it
to 2 seconds ten seconds after the port is shut down, this port is recovered immediately.
Examples
# Set the detection timer to 100 seconds.
<Sysname> system-view
[Sysname] shutdown-interval 100

statistic mode

Use statistic mode to set the packet statistics collection mode.
Use undo statistic mode to restore the default.
Syntax
statistic mode { queue | vsi }
undo statistic mode
Default
The packet statistics collection mode is vsi.
Views
System view
Predefined user roles
network-admin
Parameters
queue: Collects outgoing packet statistics for interfaces on a per-queue basis.
vsi: Collects packet statistics for VSIs.
Usage guidelines
The device supports the following packet statistics collection modes:
queue—Collects outgoing packet statistics for interfaces on a per-queue basis. To display the
•
statistics, use the display qos queue-statistics command. For more information about this command,
see ACL and QoS Command Reference.
vsi—Collects packet statistics for VSIs. To change the statistics collection mode from queue to vsi,
•
you must also use the statistics enable command to enable packet statistics for VSIs. To display the
statistics, use the display l2vpn vsi verbose command. For more information about this command,
see VXLAN Command Reference.
If you configure this command multiple times, the most recent configuration takes effect.
241