Temperature-Limit - HP FlexFabric 12900 series Command Reference Manual

temperature-limit

Use temperature-limit to set the temperature alarm thresholds for the device.
Use undo temperature-limit to restore the default.
Syntax
In standalone mode:
temperature-limit slot slot-number { hotspot | inflow } sensor-number lowlimit warninglimit [ alarmlimit ]
undo temperature-limit slot slot-number { hotspot | inflow } sensor-number
In IRF mode:
temperature-limit chassis chassis-number { slot slot-number } { hotspot | inflow } sensor-number lowlimit
warninglimit [ alarmlimit ]
undo temperature-limit chassis chassis-number { slot slot-number } { hotspot | inflow } sensor-number
Default
To view the default settings, use the undo temperature-limit command to restore the defaults and then
execute the display environment command.
Views
System view
Predefined user roles
network-admin
Parameters
chassis chassis-number: Specifies an IRF member device by its member ID. (In IRF mode.)
slot slot-number: Specifies a card by its slot number.
hotspot: Configures temperature alarm thresholds for hotspot sensors. A hotspot sensor is typically near
the chip that generates a great amount of heat and used to monitor the chip.
inflow: Configures temperature alarm thresholds for inlet sensors. An inlet sensor is near the air inlet and
is used to monitor the ambient temperature.
sensor-number: Specifies a sensor by its number, an integer starting from 1. Each number represents a
temperature sensor on the device or card.
lowlimit: Specifies the low-temperature threshold in Celsius degrees.
warninglimit: Specifies the high-temperature warning threshold in Celsius degrees. This threshold must
be greater than the low-temperature threshold.
alarmlimit: Specifies the high-temperature alarming threshold in Celsius degrees. This threshold must be
greater than the high-temperature warning threshold.
Usage guidelines
Different cards support different types of temperature sensors. To view supported temperature sensor
types, use the display environment command.
The sensor number value ranges and threshold value ranges vary by card model. Use the CLI online help
system to view the value ranges.
245