Activate Jet Pumps; Light On/Off Button; Light Mode Button - Jacuzzi J-375 Owner's Manual

1. Press and hold
2. Press and hold the
time for 2 seconds. You will see the
temperature change to 105°F (40.5°C)
on the LCD display. Press
the temperature to 106°F (41°C) To
lower the temperature, press
3. When the overtemp has been activated, the asterisk after the last
digit will appear as an indicator for being in the overtemp mode,
Figure 10.3a.
Note: Once the temperature goes below 104°F (40°C) and you would
like to raise the temperature to 106°F (41°C) again, you will have to
repeat the steps.
10.4

Activate Jet Pumps

The JETS 1 (
turns jets pump 1 on; the second press turns jets pump 1 off.
The JETS 2 (
The first press turns jets pump 2 on; the second press turns
jets pump 2 off. When manually activated, either pump will automatically
turn off after 20 minutes.
10.5

Light On/Off Button

Pressing this button activates the waterfall light, footwell light,
lighted cup holders, and backlit pillows lights in unison as
follows: high - medium - low - off.
Note: Lights automatically turn off after 2 hours.
10.6

Light Mode Button

This button offers 4 light modes for your enjoyment. Press this
button to select your favorite lighting effect as follows:
1st press
2nd press
3rd press
4th press
5th press
6th press
7th press
8th press
9th press
10th press
11th press
then;
at the same
1
) button activates jets pump 1. The first press
1
) button activates jets pump 2 (if equipped).
2
high speed blend mode
low speed blend mode
freezes low speed blend mode
solid Blue color
solid Violet color
solid Red color
solid Amber color
solid Green color
solid Aqua color
solid Near White color
goes back to high speed blend mode
to raise
.
J-300
1
2
Figure 10.3a
1
2
29