General Electrical Safety Instructions - Jacuzzi J-375 Owner's Manual

J-300
If the home Wi-Fi router signal is
strong (3-4 bars) and Internet
access is stable, the proposed
installation site is a good choice.
If the home router's Wi-Fi signal is
weak and Internet access is slow
or produces an error, the proposed
installation site is not a good choice.
• It may be necessary
to choose another spa
installation site.
• Relocate your home Wi-Fi
router closer to the spa.
• Install a "repeater" device
in the room closest to the
spa to boost the home's router Wi-Fi signal at the
proposed spa installation site.
5.0

General Electrical Safety Instructions

Your new Jacuzzi spa is equipped with a "state-of-the-art"
equipment system. It contains the most advanced safety
and self-protective equipment in the industry. Nonetheless,
this spa must be installed properly to insure dependable
usage. Please contact your dealer or local building department should
you have any questions regarding your installation.
Proper grounding is extremely important. Jacuzzi spas are equipped with
a current collector system. A pressure wire connector is provided on the
surface of the control box, located outside the equipment door (Figure
B, page 17) to permit connection of a bonding wire between this point
and any ground metal equipment, metal water pipe or conduit within 5
feet (1.5m) of the spa, or copper clad grounding rod buried within 5 feet
(1.5m) of the spa. Bonding wire must be at least No. 8 AWG (8.4 mm²)
solid copper wire. This is a most important safety assurance feature.
Before installing this spa, check with the local building department to
insure installation conforms to local building codes.
120/240 Volt Convertible Models
A spa connected to a 120 VAC electrical service must be located close
enough to a grounded, grounding-type electrical outlet so that the
included 10 feet (3m) power cord can be plugged directly into it. DO NOT
USE AN EXTENSION CORD as this could cause damage to the spa's
equipment due to insufficient voltage. The power supplied to this spa
must be a dedicated circuit with no other appliances or lights sharing the
power provided by the circuit.
12
Home WiFi
Router
Figure 4.3