General Electrical Safety Instructions - Jacuzzi J-230 Owner's Manual

J-200 Series
3. Observe a reasonable time limit when using the spa. Long exposures at
higher temperatures can cause high body temperature. Symptoms may
include dizziness, nausea, fainting, drowsiness, and reduced awareness.
These effects could possibly result in drowning.
4. Do not use the spa under the influence of alcohol, narcotics, or other drugs.
Use of the spa under these conditions may lead to serious consequences.
5. Always test the spa water temperature before entering the spa. Enter and
exit the spa slowly. Wet surfaces can be very slippery.
6. Never bring any electrical appliances into or near the spa. Never operate
any electrical appliances from inside the spa or when you are wet unless
such appliances are built-in by the manufacturer.
7. Proper chemical maintenance of spa water is necessary to maintain safe
water and prevent possible damage to spa components.
8. Use the straps and clip tie downs to secure the cover when not in use. This
will help to discourage unsupervised children from entering the spa and
keep the spa cover secure in high-wind conditions. There is no representa-
tion that the cover, clip tie-downs, or actual locks will prevent access to the
spa.

3.4 General Electrical Safety Instructions

Your new Jacuzzi® spa is equipped with a "state-of-the-art" equipment system.
It contains the most advanced safety and self-protective equipment in the indus-
try. Nonetheless, this spa must be installed properly to ensure dependable usage.
Please contact your local Jacuzzi dealer or local building department should you
have any questions regarding your installation.
Proper grounding is extremely important. Jacuzzi spas are equipped with a
current collector system. A pressure wire connector is provided on the surface
of the control box, located outside the equipment door (Figure-B, page 14) to
permit connection of a bonding wire between this point and any ground metal
equipment, metal water pipe or conduit within 5 feet (1.5m) of the spa, or cop-
per clad grounding rod buried within 5 feet (1.5m) of the spa. Bonding wire
must be at least No. 8 AWG (8.4mm
tant safety assurance feature.
Before installing your spa, check with your local building department to insure
installation conforms to local building codes.
6
2
) solid copper wire. This is a most impor-