Electrical Requirements - Jackson DishStar HT Installation, Operation And Service Manual

High temperature undercounter dishwasher

Hide thumbs Also See for DishStar HT:

Installation quick manual (2 pages)

Quick start manual (2 pages)

Installation, operation and service manual (76 pages)

Table Of Contents

Table of Contents

SPECIFICATIONS

NOTICE

All electrical ratings provided in this manual are for reference

only. Always refer to the machine data plate to get exact electrical

information for this machine. All electrical work performed on

machines should be done in accordance with applicable

local, state, territorial, and national codes. Work should only

be performed by qualified electricians and authorized service

agents.

Note that all electrical wiring used in the DishStar

machines must be rated, at a minimum, for 212 °F (100 °C), and

that only copper conductors must be used.

Where applicable, heating element amperage draws have been

adjusted for the assumed input voltage. The manufacturer

assumes incoming voltages will be either 208 or 230 Volts. Some

heating elements used in the machines are rated for other voltages,

such as 240 Volts and 480 Volts. Always verify the amperage

draw of the machine in operation when sizing circuit protection.

If the dishmachine is equipped with the optional rinse heater, note

the rinse heater might have its own electrical connection and

require a separate service. Amperage loads for motors and heaters

are indicated on the machine data plate.

The electrical configurations of the DishStar

are as follows:

Available Electrical Characteristics:

208 V, 60 Hz, Single-phase

•

230 V, 60 Hz, Single-phase

•

LT/LT-H

115 V, 60 Hz, Single-phase

•

Available Wash Tank Heaters:

•

1.5 kW (LT-H Only)

*The DishStar

LT-H is designed so that the wash motor is never

running when the wash heater is on. Total Load is based on the

higher of the two loads.

07610-004-37-13-E

series of machines