Deliming - Jackson DishStar HT Installation, Operation And Service Manual

OPERATION

DELIMING

NOTICE
NOTE: If this machine is
equipped with an
HTS-11 scale prevention
and corrosion control
device and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, call the
manufacturer.
07610-004-37-13-E
OPERATING INSTRUCTIONS
To proceed with the delime operation, follow the steps below. The tank capacities of
the machine can be found in the Specifications section of this manual.
1. Remove rinse arms and place in sink with deliming solution (HT only).
2. Flip the "ON/OFF" switch to the "ON" position.
3. Flip the "WASH/DELIME" switch to the "DELIME" position.
4. Add deliming solution per chemical supplier's instructions.
5. Close the door.
6. Push the "START" button.
7. Wait until cycle is complete and inspect the inside of the machine. If the
machine is not delimed, run again.
This equipment is not recommended for use with deionized water or other aggressive
fluids. Use of deionized water or other aggressive fluids will result in corrosion and
failure of materials and components. Use of deionized water or other aggressive fluids
will void the manufacturer's warranty.
17