Cisco Catalyst 2960 Command Reference Manual page 439

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
Defaults
The sending of SNMP traps is disabled.
Command Modes Global configuration
Command History Release
12.2(25)FX
Usage Guidelines Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
When supported, use the snmp-server enable traps command to enable sending of traps or informs.
Note Informs are not supported in SNMPv1.
To enable more than one type of trap, you must enter a separate snmp-server enable traps command
for each trap type.
Examples
This example shows how to send VTP traps to the NMS:
Switch(config)# snmp-server enable traps vtp
You can verify your setting by entering the show vtp status or the show running-config privileged
EXEC command.
Related Commands Command
show running-config
snmp-server host
78-16882-01
Modification
This command was introduced.
Description
Displays the running configuration on the switch. For syntax information,
select Cisco IOS Configuration Fundamentals Command Reference,
Release 12.2 > File Management Commands > Configuration File
Management Commands.
Specifies the host that receives SNMP traps.
snmp-server enable traps
Catalyst 2960 Switch Command Reference
2-411