Set - Cisco Catalyst 2960 Command Reference Manual

set

set
Use the set policy-map class configuration command to classify IP traffic by setting a Differentiated
Services Code Point (DSCP) or an IP-precedence value in the packet. Use the no form of this command
to remove traffic classification.
Syntax Description
dscp new-dscp
ip precedence new-precedence
Defaults
No traffic classification is defined.
Command Modes Policy-map class configuration
Command History Release
12.2(25)FX
Usage Guidelines If you have used the set ip dscp command, the switch changes this command to set dscp in the switch
configuration. If you enter the set ip dscp command, this setting appears as set dscp in the switch
configuration.
The set command is mutually exclusive with the trust policy-map class configuration command within
the same policy map.
For the set dscp new-dscp or the set ip precedence new-precedence command, you can enter a
mnemonic name for a commonly used value. For example, you can enter the set dscp af11 command,
which is the same as entering the set dscp 10 command. You can enter the set ip precedence critical
command, which is the same as entering the set ip precedence 5 command. For a list of supported
mnemonics, enter the set dscp ? or the set ip precedence ? command to see the command-line help
strings.
To return to policy-map configuration mode, use the exit command. To return to privileged EXEC mode,
use the end command.
Catalyst 2960 Switch Command Reference
2-242
set {dscp new-dscp | ip precedence new-precedence}
no set {dscp new-dscp | ip precedence new-precedence}
Modification
This command was introduced.
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
New DSCP value assigned to the classified traffic. The range
is 0 to 63. You also can enter a mnemonic name for a commonly
used value.
New IP-precedence value assigned to the classified traffic. The
range is 0 to 7. You also can enter a mnemonic name for a
commonly used value.
78-16882-01