Set Up The Primary Cisco Nexus 1100 Series Vsa - Cisco Nexus 1110-S Deployment Manual

Nexus 1100 series virtual services appliances
Table of Contents

Advertisement

Set Up the Primary Cisco Nexus 1100 Series VSA

With the upstream access switch configured in preparation for the Cisco Nexus 1100 Series, power on the Cisco
Nexus 1100 Series VSA. Follow these steps to set up the primary Cisco Nexus 1100 Series VSA:
1.
When asked, enter and confirm the administrator password.
---- System Admin Account Setup ----
Enter the password for "admin":
Confirm the password for "admin":
2.
When asked, enter the high-availability role. If you do not specify a role, then the primary role is assigned.
Enter HA role[primary/secondary]: primary
Note:
3.
When asked, enter the uplink type.
Note:
Enter network-uplink type <1-4>:
1. Ports 1-2 carry all management, control and data vlans
2. Ports 1-2 management and control, ports 3-6 data
3. Ports 1-2 management, ports 3-6 control and data
4. Ports 1-2 management, ports 3-4 control, ports 5-6 data
5. Flexible
3
4.
When asked, enter the VLAN ID for the control VLAN.
Enter control vlan <1-3967, 4048-4093>: 50
5.
When asked, enter the domain ID.
Enter the domain id<1-4095>: 55
6.
When asked, enter the VLAN ID for the management VLAN.
Enter management vlan <1-3967, 4048-4093>: 172
Saving boot configuration. Please wait...
[########################################] 100%
7.
When asked if you want to enter the basic configuration dialog box, respond yes.
Would you like to enter the basic configuration dialog (yes/no): yes
---- Basic System Configuration Dialog ----
This setup utility guides you through the basic configuration of the system. Setup configures only enough
connectivity for management of the system.
Press Enter at any time to skip a dialog box. Press Ctrl-C at any time to skip the remaining dialog boxes.
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
The high-availability standalone role is not supported for the Cisco Nexus 1100 Series.
After you configure an uplink type, the only way to modify it is to reload the software.
Page 29 of 39

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nexus 1110-x

Table of Contents