Handset; Speaker; Safety - Cisco 7902G Administration Manual

Before You Begin

Handset

Speaker

Safety

Warning
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
3-4
Use the network port to connect the phone to the network. You must use a
straight-through cable on this port. The phone can also obtain inline power from
the Cisco Catalyst switch over this connection. See the
Cisco Unified IP Phone" section on page 2-7
Use the access port to connect a network device, such as a computer, to the phone.
You must use a straight-through cable on this port.
See Figure 3-1 for the connection ports available on the back of the
Cisco Unified IP Phone 7902G and 7905G. See
ports available on the back of the Cisco Unified IP Phone 7912G.
The handset is designed especially for use with a Cisco Unified IP Phone. It
includes a light that indicates incoming calls and voice messages waiting.
This Cisco Unified IP Phone 7905G and 7912G include a speaker that you can use
to monitor calls.
To disable the speaker on these models, choose Device > Phone from the
Cisco Unified CallManager Administration application, locate the phone you
want to modify, and check the Disable Speakerphone check box.
Review the following warnings before installing the Cisco Unified IP Phone. To
see translations of these warnings, refer to the Regulatory Compliance and Safety
Information for the Cisco Unified IP Phone 7900 Series document that
accompanied this device.
Read the installation instructions before you connect the system to its power
source.
Chapter 3 Setting Up the Cisco Unified IP Phone
"Providing Power to the
for details.
Figure 3-2 for the connection
OL-8151-01