Using A Handset, Headset, And Speakerphone; Obtaining A Headset - Cisco 7970 Phone Manual

Using a Handset, Headset, and Speakerphone

The table below describes how to use these devices.
If you want to...
Use the handset
Use a headset
Use the speakerphone
Switch to the headset or
speakerphone (from the handset)
during a call
Switch to the handset (from the
speakerphone or headset) during a
call
Tips
• See the "Connecting Your Phone" section on page 5 to locate the headset port.
• See the "Basic Call Handling" section on page 16 for detailed instructions about how to use the
handset, headset, and speakerphone to place, answer, end, and otherwise handle calls.

Obtaining a Headset

Your phone supports four- or six-wire headset jacks. For information about purchasing headsets, see
the following URL: http://vxicorp.com/cisco
Cisco IP Phone 7970
Then...
Lift it to go off-hook; replace it to go on-hook.
Press to toggle headset mode on and off. (AutoAnswer users
should see the "Using AutoAnswer with a Headset or the
Speakerphone" section on page 30 for exceptions.)
You can use the headset in conjunction with all of the controls
on your phone, including
See the "Obtaining a Headset" section on page 29 for headset
purchasing information.
Press to toggle speakerphone mode on or off.
Many of the actions you can take to dial a number or answer a
call will automatically trigger speakerphone mode, assuming
that the handset is in its cradle and the
not lit.
Press or , then hang up the handset.
Lift the handset (without pushing any buttons).
Using a Handset, Headset, and Speakerphone
and
(headset button) is
.
29