Appendix; Updating Firmware For The Cisco Unified Ip Phone - Cisco 7902G Administration Manual

Updating Firmware for the
Cisco Unified IP Phone
You can use the upgradecode parameter in a profile file to provide special upgrade
instructions for the Cisco Unified IP Phone 7902G, 7905G, and 7912G.
For detailed information about using profile files, see
Configuration Methods and Parameters."
To provide upgrade instructions to a phone, add the following line to the
Cisco Unified IP Phone profile file:
upgradecode:3, type ,0x0400,0x0100, tftp_server_ip ,69, image_id ,
image_file_name
where:
•
•
•
•
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
OL-8151-01
type is 0x401 for the Cisco Unified IP Phone 7902G, 0x501 for the
Cisco Unified IP Phone 7905G, or 0x601 for the
Cisco Unified IP Phone 7912G.
tftp_server_ip is the IP address of the TFTP server on which the firmware
upgrade image is stored. Enter 0 to use the TFTP server specified by the
TFTPServer1 parameter or by DHCP.
image_id is a unique 32-bit integer value. This value must be different for
each upgrade. For this value, it is convenient to use 0x followed by the build
date on the image file name. (For example, if the image file name is
CP79050101SCCP030323A.ZUP, then the build date is 30323A, and
image_id would be 0x30323A.)
image_file_name is the file name of the firmware upgrade image.
A P P E N D I X
Appendix A, "Additional
E
E-1