Adjust The Handset Rest; Change The Viewing Angle Of Your Phone - Cisco 7800 Series User Manual

CISCO 7800 SERIES

Adjust the Handset Rest

If your phone is wall-mounted or if the handset slips out of the cradle too easily, you may need to adjust the
handset rest to ensure that the receiver does not slip out of the cradle.
Figure 1: Adjust the Handset Rest
Procedure
Step 1 Remove the handset from the cradle and pull the plastic tab from the handset rest.
Rotate the tab 180 degrees.
Step 2
Hold the tab between two fingers, with the corner notches facing you.
Step 3
Line up the tab with the slot in the cradle and press the tab evenly into the slot.
Step 4
An extension protrudes from the top of the rotated tab.
Step 5
Return the handset to the handset rest.

Change the Viewing Angle of Your Phone

You can change the angle of the phone, except the Cisco IP Phone 7811, to eliminate glare on the screen.
Procedure
Step 1
Unplug the phone from the network.
Step 2 Place the phone so that the keypad faces the desktop.
Step 3
Grasp one side of the footstand with one hand and place your other hand on the phone.
Step 4 Hold down the phone and pull up on the footstand.
GoMomentum.com 4
USER GUIDE
888.538.3960