Rack mount checklist
This section describes the contents of the rack mount kit as well as tools or equipment required to
complete the installation.
NOTE:
The hardware kit includes parts not required for the configuration described in these
instructions.
Rack mount kit contents
•
Two adjustable bracket assemblies (adjustable for length 24 to 32 inches)
•
Two fixed length side-mount rails
•
Two left ear brackets for flush mounting
•
Two right ear brackets for flush mounting
•
Eight panhead screws (10-32 x 1/2 inch)
•
Ten flathead countersink screws (#6 x 3/8 inch)
•
Eight square alignment washers
•
Two cable routing hook-and-loop straps
•
Torx tool
Mounting hardware
•
Two two-hole bar nuts
•
Six three-hole bar nuts (only four used)
•
Eight square alignment washers (required only for HP 9000, 10000 and 11000 series racks)
Eight Phillips panhead screws (10-32 x 1/2) with split lock and flat washers
•
•
Four Phillips flathead screws (8-32 x 7/16)
•
Ten Phillips panhead screws (10-32 x 5/8) with flat washer (only 2 used)
•
Six Phillips flathead screws (6-32 x 3/8) (not used)
•
Twelve Phillips panhead screws (10-32 x 3/8) (not used)
•
Four 8-32 Keps nuts (not used)
Required tools
The following tools are required, but are not included in the kit:
•
Torque driver with a T10 Torx bit
•
#2 Phillips screwdriver
26
Installing the Edge Switch