HP 316095-B21 Installation Manual page 84

When the parameter is disabled, attached devices (registered through the fabric format
domain register) do receive notification following any change to the fabric's active zone set.
e. Select (enable) or clear (disable) the Limited Fabric RSCN check box.
When enabled, RSCNs are not transmitted after a product initial program load (IPL).
f. Select (enable) or clear (disable) the Zone Flexpars: Isolate Fabric RSCNs on zone activation
changes check box.
When enabled, zone FlexPars isolate and prevent fabric-format RSCNs from propagating to
devices in zones that are not impacted.
g. Enter a value from 1 through 31 (default is 1) in the Preferred Domain ID box.
The domain ID uniquely identifies each switch in a fabric.
NOTE:
unique, the E_Port connection to the switch segments and the switch cannot communicate
with the fabric.
h. Select By Port Speed or Ignore Port Speed from the ISL FSPF Cost Configuration drop-down
list.
• By Port Speed—The fastest fabric path is determined by port (ISL) speed. Cost is inversely
proportional to speed.
• Ignore Port Speed—ISL speed is ignored, and the fastest fabric path is determined by the
number of hops. Cost is directly proportional to hop count.
4. Click OK to save the information.
The following message is displayed:
Your changes have been successfully activated
5. Set the Edge Switch online (see
To configure fabric parameters:
1. Set the Edge Switch offline (see
2. Select Configure > Switch > Fabric Parameters.
The Fabric Parameters view is displayed
84 Using the HAFM Basic interface
All fabric-attached switches must have a unique domain ID. If the value is not
"Setting the Edge Switch offline and
"Setting the Edge Switch offline and
(Figure 50).
online" on page 77).
online" on page 77).