Using The Hafm Basic Interface; Launching The Hafm Basic Interface - HP 316095-B21 Installation Manual

5

Using the HAFM Basic interface

If an HAFM appliance is not available or is not used to manage the Edge Switch, you can use the
HAFM Basic interface to configure the Edge Switch 2/32 . Selectively perform the following
configuration tasks according to your installation requirements:
• Launching the HAFM Basic
• Setting the Edge Switch offline and
• Configuring Edge Switch
• Configuring BB
• Configuring Edge Switch
• Configuring date and
• Configuring Edge Switch
• Configuring network
• Configuring SNMP trap message
• Enabling or disabling the
• Configuring
NOTE: This chapter describes the initial set up of the Edge Switch using the HAFM Basic interface.
For additional information on configuring advanced features using HAFM Basic interface, see the
HAFM Basic online help or the HAFM Basic user guide.

Launching the HAFM Basic interface

Use the following steps to launch the HAFM Basic interface:
NOTE: Internet access and a standard web browser is required. HP recommends Netscape
Navigator 4.6 or higher or Microsoft Internet Explorer 4.0 or higher.
1. Ensure that the browser-capable PC and the Ethernet LAN segment (with the Edge Switch
attached) are connected.
2. At the PC, launch the browser (Netscape Navigator or Internet Explorer).
interface, page 75
ports, page 77
credit, page 79
identification, page 80
time, page 81
parameters, page 82
information, page 86
recipients, page 87
CLI, page 89
zoning, page 98
online, page 77
Edge Switch 2/32 installation guide 75