HP 316095-B21 Installation Manual page 66

NOTE:
6. Enter a percentage from 1 through 100 for % utilization.
When throughput reaches this percentage of port capacity, a threshold alert occurs.
7. Enter the amount of cumulative minutes in which the % utilization should exist during the
notification interval before an alert is generated.
You can also select At any time if you want an alert to occur whenever the set % utilization is
reached. The valid range is from 1 to the interval value set in
8. Enter the interval in minutes in which throughput is measured and threshold notifications can
occur.
The valid range is 5 minutes to 70,560 minutes.
9. Click Next.
A new screen is displayed for selecting ports for the alerts
Figure 35 New Threshold Alerts dialog box
10.Select either Port Type or Port List:
• For Port Type, select either E_Ports or F_Ports to cause this alert to be generated for all ports
configured as E_Ports or F_Ports respectively.
• For Port List, you can select individual ports by selecting the check box by each port number
or clicking Set All Ports. Selecting Set All Ports places a check mark by each port number.
Selecting Clear All Ports clears the check marks by each port number.
11.Click Next.
66 Using HAFM to configure the Edge Switch
Click Previous if you need to return to the previous screen.
step
(Figure
third screen
—
8.
35).