6 Configuration and Settings
6.2 Configuring the SINAMICS G drive
6.2
Configuring the SINAMICS G drive
Tabelle 6-2
No.
Action
1.
If still unsuccessful, install the
STARTER commissioning
/8/
software (see
2.
Connect SINAMICS G and S7-
300 via a PROFIBUS cable and
the S7-300 and the PG/PC via a
network cable.
3.
Start the SIMATIC Manager and
open the project created in
chapter
6.1 "Configuring the S7-
300/400F
controller".
4.
Click on SINAMICS G.
Depending on the used
project, it is called...
G120_CU240E-2_DP_F
G120_CU240E-2_DP
G120_CU250S-2_DP
G120_CU240D-2_DP_F
G120_CU240D-2_DP
G120C_DP
G110M_DP
Click 2x on
"Commissioning".
This opens the STARTER
with the project.
SINAMICS G120C at S7-300/400F-DP
Beitrags-ID: 60441457,
V2.2,
).
SINAMICS G120
The picture shows the example of a SINAMICS G120 with
CU 240E-2 DP-F.
11/2014
Remarks
S7-300/400
PROFIBUS
Ethernet
75