Downloading The Sinamics Configuration; Preparations For Using The Lan Port Of The Pg/Pc - Siemens SINAMICS G120 Manual

3 Setup and Commissioning

3.7 Downloading the SINAMICS configuration

3.7 Downloading the SINAMICS configuration
This chapter describes the steps for downloading the example configuration.
This can be done either via the network (LAN) port (with routing through the
SIMATIC S7 CPU) or directly via a USB port of the PG/PC.
Should you use a different SINAMICS G or motor you need to perform your own
Note
configuration. Follow the instructions in chapter
drive", especially steps
In the screenshots below, a SINAMICS G120 is used. In the instruction texts
deviating names of the other SINAMICS G120 converter types might be mentioned.
The SIMATIC S7-300/400F CPU must support data record routing. (CPU 31x with
FW3.x or CPU 41x with FW5.1 or newer), see /12/.
3.7.1

Preparations for using the LAN port of the PG/PC

To be able to use routing, the PG/PC is inserted and an Ethernet network is
configured in the network configuration in the sample programs.
As you are using a network card that differs from the one used when creating the
project, your network card must be assigned to the configured PG/PC.
In addition, the following requirements must be met:
The SIMATIC program has already been downloaded to the SIMATIC S7 CPU,
see chapter 3.6.
The PROFIBUS connection between SIMATIC S7-300/400F CPU and
SINAMICS G was established.
The PROFIBUS address (in the example: 5) of the SINAMICS G was set using
DIP switches (or via P918), followed by a power reset.
Table 3-4
No. Action
1.
Open the project.
Double-click on "PG/PC(1)".
SINAMICS G120C at S7-300/400F-DP
Beitrags-ID: 60441457, V2.2,
11 and 12.
11/2014
"Configuring the SINAMICS G120
Remark
21