Transfer Deflector Removal; Bottom Side Removals; T652, T654, And T656 Duplex Assembly Removal - Lexmark T652 Service Manual

Transfer deflector removal
1
Remove the transfer roll assembly. Go to
2
Gently unsnap the transfer deflector from the machine.
3
Remove the transfer deflector.
4
Remove the screw (A) securing the ground wire to the transfer deflector.
5
Remove the ground wire.
Installation warning: When replacing the transfer deflector, ensure that the ground wire is properly
replaced.

Bottom side removals

T652, T654, and T656 duplex assembly removal

Note: When removing the duplex drive motor assembly, it does not need to be completely removed from the
machine. It may be allowed to gently hang out of the way by the harness.
1
Remove the duplex drive motor assembly. See
removal" on page 328.
2
Remove the pick arm assembly. See
3
Remove the four screws (A) securing the duplex assembly to the machine.
4
Remove the harnesses (B) from the clamp.
"Transfer roll assembly removal" on page
"T652, T654, and T656 duplex drive motor assembly
"Pick arm assembly removal" on page
Repair information
316
314.
A
320.
4062