Waiting; 30 Invalid Refill, Change Cartridge; 31 Replace Defective Cartridge; 32 Cartridge Part Number Unsupported By Device - Lexmark T652 Service Manual

Waiting

The printer has received data to print, but is waiting for an End‑of‑Job command, a Form Feed command,
or additional data.
Try one or more of the following:
•
Press to print the contents of the buffer.
•
Cancel the current print job.
30 Invalid refill, change cartridge
Remove the print cartridge, and then install a supported one.

31 Replace defective cartridge

Remove the defective print cartridge, and then install a new one.

32 Cartridge part number unsupported by device

Remove the print cartridge, and then install a supported one.

34 Short paper

Try one or more of the following:
•
Load the appropriate paper in the tray.
•
Press the arrow buttons until
print the job using a different paper tray.
•
Check tray length and width guides and make sure the paper is properly loaded in the tray.
•
For Windows users, check the Print Properties settings to make sure the print job is requesting the
correct paper size and type.
For Macintosh users, check the Print dialog settings to make sure the print job is requesting the correct
paper size and type.
•
Check that the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, make
sure the paper is large enough for the data being printed.
•
Cancel the current print job.

35 Insufficient memory to support Resource Save feature

Try one or more of the following:
•
Press the arrow buttons until
continue printing.
•
To enable Resource Save after receiving this message, make sure the link buffers are set to Auto, and
then exit the menus to activate the link buffer changes. When Ready appears, enable Resource Save.
•
Install additional memory.
Continue appears, and then press
Continue appears, and then press
Diagnostic information
172
to clear the message and
to disable Resource Save and
4062