Ep Setup - Lexmark T652 Service Manual

Edge to Edge
When enabled, this setting shifts all four margins (top, bottom, left, and right) to the physical edge of the page
(printable area of a supported paper size).
Set the setting to Off to restore normal margins.

EP SETUP

EP Defaults
This setting restores each printer setting listed in EP SETUP to its factory default value. This is also used to help
correct print quality problems.
1
From the Diagnostics menu, navigate to EP SETUP > EP Defaults.
2
Select one of the following:
•
Restore—To restore the default values.
•
Do Not Restore—To exit without changing the settings.
Fuser Temperature (Fuser Temp)
This setting adjusts the fuser temperature to solve problems with paper curl on low‑grade paper and problems
with letterheads on some types of media.
1
From the Diagnostics menu, navigate to EP SETUP > Fuser Temp.
2
Set the fuser temperature to Normal, Lower, or Lowest.
Note: Normal is the factory default setting.
Fuser Page Count
Note: The fuser page count can only be viewed.
From the Diagnostics menu, navigate to EP SETUP > Fuser Page Count.
Warm Up Time
This setting determines the amount of time the printer warms up before allowing the pages to print. The factory
default setting is 0. This time period lets the backup roll heat up and helps reduce curl in some environments.
Transfer
This setting can be set to Low, Medium, or High. Medium is the factory default setting.
Service menus
252
4062