Siemens SIMATIC ET 200SP Manual page 34

Configuring/address space
4.4 Parameters
Parameter setting via ...
Hardware configuration in STEP 7
(TIA Portal) in "Manual operation
(without technology object)" operating
mode
Hardware configuration in STEP 7
(TIA Portal) in "Fast Mode" operating
mode
Hardware configuration in STEP 7
(TIA Portal) with HSP
Hardware configuration in STEP 7
with HSP
34
Basic procedure
1. Select an appropriate CPU under "Add new device > Controller > SIMATIC
S7-1500 / SIMATIC ET 200 CPU"".
2. For distributed operation, select an interface module in the hardware catalog
under "Distributed I/O > ET 200SP > Interface modules".
3. Select the module in the hardware catalog under "Technology modules".
4. Set the device configuration and the parameters of the module (Page 43) in the
hardware configuration.
"Manual operation (without technology object)" must be set as the operating
mode.
5. Download the parameter assignment to the module.
1. If the technology module is not yet integrated in your TIA Portal version, install
the corresponding HSP file.
2. Select an appropriate CPU under "Add new device > Controller > SIMATIC
S7-1500 / SIMATIC ET 200 CPU"".
3. For distributed operation, select an interface module in the hardware catalog
under "Distributed I/O > ET 200SP > Interface modules".
4. Select the module in the hardware catalog under "Technology modules".
5. Set the device configuration and the parameters of the module (Page 48) in the
hardware configuration.
"Fast Mode" must be set as the operating mode.
6. Download the parameter assignment to the module.
1. Install the appropriate HSP file.
2. Select an appropriate CPU under "Add new device > Controller > SIMATIC
S7-1500".
3. Select an interface module in the hardware catalog under "Distributed I/O >
ET 200SP > Interface modules".
4. Select the module in the hardware catalog under "Technology modules".
5. Set the device configuration and the parameters of the module in the hardware
configuration.
6. Download the parameter assignment to the module.
1. Install the corresponding HSP file.
You will then find the module in the Hardware catalog under "ET 200SP".
2. Set the device configuration and the parameters in the hardware configuration.
3. Download the parameter assignment to the module.
Technology Module TM Count 1x24V (6ES7138-6AA00-0BA0)
Manual, 02/2017, A5E33002339-AB