Dell S6000 Reference Manual page 81

cam-acl
{default | l2acl
number ipv4acl
number ipv6acl
number,
ipv4qos
number l2qos
numberl2ptnu
mber ipmacacl
number
ecfmacl
number [vman-
qos | vman-
dual-qos
number}
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.2(0.2)
Version 9.1.
(0.0)
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.3.1.0
Version 8.2.1.0
Version 7.8.1.0
Usage
For the new settings to take effect, save the new CAM settings to the startup-
Information
config (write-mem or copy run start) then reload the system.
Control and Monitoring
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space
to be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller
(256 total entries minus the 14 entries reserved for
internal functionality)
• 8: Creates 498 entries for use by the OpenFlow controller
(512 total entries minus the 14 entries reserved for
internal functionality)
Enter the CAM profile name followed by the amount to be
allotted. The total space allocated must equal 13. The ipv6acl
range must be a factor of 2.
Introduced on the S6000.
Added support for the fcoe parameter on the S4810 and
S4820T.
Added support for OpenFlow on the Z9000.
Introduced on the S4820T.
Added the keywords fcoeacl and iscsioptacl on the
S4810.
Introduced on the Z9000.
Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Introduced on the S-Series.
Introduced on the C-Series.
81