Dell S6000 Reference Manual page 667

Line
Output Statistics:
Rate information...
Time since...
Example
Dell#show interfaces
TenGigabitEthernet 2/0 is down, line protocol is down
Hardware is DellForce10Eth, address is 00:01:e8:8b:3d:e7
Current address is 00:01:e8:8b:3d:e7
Pluggable media present, Media type is unknown
Wavelength unknown
Interface index is 100992002
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 3d17h53m
Interfaces
Description
– giants = packets that are greater than the MTU size
– throttles = packets containing PAUSE frames
• Number of CRC, overrun, and discarded packets:
– CRC = packets with CRC/FCS errors
– overrun = number of packets discarded due to FIFO
overrun conditions
– discarded = the sum of runts, giants, CRC, and
overrun packets discarded without any processing
Displays output statistics sent out of the interface including:
• Number of packets, bytes, and underruns out of the
interface
• Packet size and the number of those packets outbound
to the interface
• Number of Multicast, Broadcast, and Unicast packets:
– Multicasts = number of MAC multicast packets
– Broadcasts = number of MAC broadcast packets
– Unicasts = number of MAC unicast packets
• Number of VLANs, throttles, discards, and collisions::
– Vlans = number of VLAN tagged packets
– throttles = packets containing PAUSE frames
– discarded = number of packets discarded without
any processing
– collisions = number of packet collisions
– wred=count both packets discarded in the MAC and
in the hardware-based queues
Estimate of the input and output traffic rate over a
designated interval (30 to 299 seconds). Traffic rate is
displayed in bits, packets per second, and percent of line
rate.
Elapsed time since the last interface status change
(hh:mm:ss format).
667