Dell S6000 Reference Manual page 207

fragments
Defaults Not configured
Command CONFIGURATION-EXTENDED-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.10
Usage
The monitor option is relevant in the context of flow-based monitoring only. For
Information
more information, refer to
The order option is relevant in the context of the Policy QoS feature only. The
following applies:
•
•
•
•
•
Access Control Lists (ACL)
Enter the keyword fragments to use ACLs to control packet
fragments.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Add the DSCP value for ACL matching.
Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the non-contiguous mask and added the
monitor option. Deprecated the keyword established.
Expanded to include the optional QoS order priority for the
ACL entry.
The seq sequence-number command is applicable only in an ACL group.
The order option works across ACL groups that have been applied on an
interface via the QoS policy framework.
The order option takes precedence over seq sequence-number.
If sequence-number is not configured, the rules with the same order value are
ordered according to their configuration order.
If sequence-number is configured, the sequence-number is used as a tie
breaker for rules with the same order.
Port Monitoring.
207