Dell S6000 Reference Manual page 366

route-map
map-name
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage If you apply a route map to a BGP peer or neighbor with the neighbor default-
Information
originate command configured, the software does not apply the set filters in the
route map to that BGP peer or neighbor.
When you configure a route-map for a BGP peer or peer group with the neighbor
default-originate command, the command checks for the existence of the
route in BGP RIB.
Route-map configuration on a BGP peer or peer group works only when the LOC-
RIB contains at least one route.
When you apply a default route to a BGP peer or peer group using the neighbor
default-originate command, changes to the configured default route-map
are applied to the BGP peer or peer group only after a delay of 15 seconds. As a
result, you must wait for a period of 15 seconds before manually resetting BGP
using the clear ip bgp command.
In case of eBGP, the neighbor default-originate command does not
support extended-community as a non-transtive route-map attribute.
You cannot set this configuration for a peer that is associated with a peer group.
Similarly, you cannot associate a peer to a peer group if that peer is already
configured with these settings.
In order that settings corresponding to the neighbor default-originate
command take effect, you must execute the clear ip bgp command
immediately after you execute the neighbor default-originate command.
366
(OPTIONAL) Enter the keyword route-map then the name
of a configured route map.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol