Dell S6000 Reference Manual page 636

tx off
Parameters
rx on
rx off
tx on
tx off
pause-thresh
old
resume-offset
Defaults rx off tx off
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Versions 6.5.1.9
and 7.4.1.0
Version 7.8.1.0
Usage
The globally assigned 48-bit Multicast address 01-80-C2-00-00-01 is used to send
Information
and receive pause frames. To allow full-duplex flow control, stations implementing
the pause operation instruct the MAC to enable the reception of frames with a
destination address equal to this multicast address.
636
Enter the keywords tx off so that flow control frames are
not sent from this port to the connected device when a
higher rate of traffic is received.
Enter the keywords rx on to process the received flow
control frames on this port.
Enter the keywords rx off to ignore the received flow
control frames on this port.
Enter the keywords tx on to send control frames from this
port to the connected device when a higher rate of traffic is
received.
Enter the keywords tx off so that flow control frames are
not sent from this port to the connected device when a
higher rate of traffic is received.
Enter the buffer threshold limit for generating PAUSE frames.
Enter the offset value for generating PAUSE frames to
resume traffic.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the E-Series.
Introduced on the C-Series and S-Series with the
thresholds option.
Interfaces